Reviewer:
Charles Brock from Beaufort, SC United States
Sprayer was shipped to me within 3 days of ordering it! Will definitely do business with you again.
Was this review helpful to you?
0 of 0 people found the following review helpful:
Lays down product like glass
May 26, 2022
Reviewer:
Ken Schneider from San Lorenzo, CA United States
Set up was easy! It took about 15 minutes to prepare the system for first use (ensure the spray cap is tight, the flow adjuster is set to not allow any product to flow when the trigger is pulled, and ensure there is no debris in the cup). I ran a cup of water (I was spraying water based material) through the gun to adjust the flow rate and fan pattern, and to clean the system. My first few runs were light passes to get the product on the doors. The second pass was a little heavier which produced the glass finish. It was a tad windy and a bit hot, so I did add a touch more water to the mix to bring the flow rate into a glass-like finish.
The MM4 hummed along in the back ground and I could turn it off (or on) when not needed - this was very helpful to keep the noise down in between tasks of moving finished pieces to the drying area.
Was this review helpful to you?
0 of 0 people found the following review helpful:
Couldn't be more impressed
December 27, 2021
Reviewer:
Micah from Victor, MT United States
For the first project, I didn't have a proper spray booth, just a mostly clean garage and I was struggling to get enough heat into the space. The Fuji mini mite 4 worked so impressively that my first attempt at blending a pearl white tri-coat on a 2006 Toyota came out impeccably. It took a little while to figure everything out and get the spray patten I wanted, but once I dialed it in everything came put beautifully. I can't possibly more highly recommend the Fuji Mini Mite 4.
Was this review helpful to you?
0 of 0 people found the following review helpful:
The best
October 31, 2021
Reviewer:
chris keeton from Danville, AL United States
Five stars for ease of use and quality. So easy to assemble and operate just five minutes out of the box and I was spraying. Verry little learning curve. I highly recommend fuji, its the best. I sprayed polyurethane with no thinning. The finish is such quality, I can't say enough about it.
Was this review helpful to you?
0 of 0 people found the following review helpful:
Fuji HPLV
September 19, 2021
Reviewer:
fan zhang from Monroe, NC United States
Love it. Still learning. Working on my kitchen carbines …